路博润ESTANE ZHF 78AT3 TPU Technical Data Sheet TYPE: Estane? ZHF 78AT3 is a Soft, Polyether based, NHFR Thermoplastic Polyurethane (TPU) Compound Description: Non-Halogenated flame retardant compound Uses: Wire and cable and general extrusion where flame retardant properties are required ? Prior to testing samples were conditioned at 23°C for 48 hours. ? Physical Property test is based on 2mm molded plaques. Listed data above is a “typical data”, and should/cannot be applied for specification pure Materials Preparation: Prior to process, Estane ZHF 78AT3 must be dried under 105o C for 3 hours. It is recommended drying this materials in a dehumidifier, target dew point to be -30o C, preferable – 40o C Depending on the process technique, the maximum moisture content is recommended <0.02%. Process Condition: Estane ZHF 78AT3 is extruded on any conventional extruder equipped with a PVC, 3 stage or barrier type screw hing an L/D ration of 25:1 and a compression ratio of 3:1 See reverse side for processing information. Physical Properties Value (Metric) Unit Test Method Hardness( 3 second ) 78 Shore A ISO 868 Specific Grity 1.12 g/mm3 ISO 2781 Tensile strength 24.1 Mpa ISO 527 Elongation at break 670 % ISO 527 Modulus at *** Elongation 4.5 Mpa ISO 527 300 % Elongation 7.5 Mpa ISO 527 Tear strength( Die C ) Nicked 62.1 KN/m ISO 34-1B Without Nick 85.2 KN/m ISO 34-1B Application Specific Properties Value (Metric) Unit Test Method UL Flame Rating V-2 - UL-94